Ethix MR Steele Stout Motor 2306 1750kv V3

333 Reward Points
SKU:
Brand: Ethix

Quantity

ADD TO WISHLIST
Found it cheaper? Click here

Sorry this item is out of stock, please complete in the form below to be notified when stock is available.

QuadCopters Price Match

Where you've seen it cheaper (UK Stores Only)

Ethix Mr Steele Stout Motor V3 1750kv 2306 perfect for freestyle and to give you the Steele Flow and built for 6s Perfection.
Comes with motor pants which wearing are optional. 

This is the 3rd and best version of the Mr Steele Ethix motor line up. This well refined piece of kit is built upon the success of its predecessors and tuned for an even higher flight envelope. The same beloved 2306 stator is in play but this time with a beefier and much smoother 9mm ball bearing (up 2mm from the previous 7mm). This allows for a thicker overall shaft adding substantial durability and more material to dissipate heat built up from consistent power hungry abusive rippers.

This stout motor v3 is also offered in a slightly higher KV for its 6S variant: 50KV up from the V2 1700KV Stout. The increase in KV adds just enough more power without dipping into the red zone of diminishing returns on efficiency. So, it’s just as efficient but with more pop.

Featuring a completely redesigned motor bell design with a recessed 6 spoke design, allows for a lower profile bell and more modern look. The lower profile design has less wind resistance and a lower center of mass, assisting throttle response. On a side note the recessed spokes also aid massively in over all durability of the bell itself. This is seriously one tough little motor.

All of these amazing new features and we were still able to keep the weight under 30g this motor comes in at 29g with the full length of wire and low profile plastic pants.

While the pants remain interchangeable with V1/V2, the V3 stator and bell is only compatible with other V3 models. You can swap SILK N48 magnet bells out for STOUT N52 magnet bells (added power and response). But since we went with a thicker shaft, these will NOT be compatible with
previous generation Steele motor parts. This is a bummer, but to innovate sometimes you have to change.

Included

  • 1x TBS Mr Steele 2306 1750kv V3 motor
  • 2x Motor Pants (Bumper and Bottom)
  • 4x Mounting screws M3x6.5
  • 1x Aluminum Low-Profile Prop Nut


These motors are offered in:

  • SILK – 2306 2345KV N48 magnets  recommended but not limited to 4/5S 5” freestyle mini quads.
  • STOUT – 2306 1750KV N52 magnets recommended for but not limited to 6S 5” freestyle mini quad setups.
    Ethix Mr Steele Stout V3 logo
OK

The item has been added to your basket

Continue Shopping
Proceed To Checkout