HQProp 6x3x3 V1S Durable Polycarbonate PC Props Light Blue

333 Reward Points
Brand: HQProp


Found it cheaper? Click here

Sorry this item is out of stock, please complete in the form below to be notified when stock is available.

QuadCopters Price Match

Where you've seen it cheaper (UK Stores Only)

HQ Prop 6x3x3 PC Propellor are specially designed for the long range FPV pilot. 

  • Length: 6 inch
  • Pitch:.6
  • Blades: 3
  • Material: Polycarbonate
  • Shaft: 5mm


  • 2x CCW Prop
  • 2x CW Prop
Harvey Lawty-Jones
Durability - fairly good as far as i can tell with my limited experience however they are quite weak at the hub of the prop so you can only bend them back a few time before they snap unlike thicker props which don't break as easily at the hub. performance - Very fast for a newer pilot like myself however i doubt these would be suitable for racing although i havens tried. efficiency - These props are by far the most efficient props i have used hovering around 7A FFF at around 20A-30A and about 80A full throttle however my ammeter on my kwad might be a bit off so take that into consideration however i can achieve 4min flights (1550mah packs) with ease if i dont do punch-outs. overall these are quite good props however i am a bit of a newb (not an experienced reviewer) and most of this is subjective anyway but if you've got a 6" try them out especially seeing as they are the only 6" props on this site. Also these should run well on higher KV motors due to the low pitch. my setup: hypetrain 2306 2450kv realacc X6R 6" frame ( alien knockoff) DYS ds30a 30a escs runcam split F4 Flame fc generic Tx Frsky r-xsr all of my electronics is con-formal coated which i would recommend as i have crashed into a river and everything was fine after it dried off.

Write your own review



The item has been added to your basket

Continue Shopping
Proceed To Checkout