Matek F405 STD F4 BetaFlight Flight Controller
QuadCopters Price Match
Matek F405 STD OSD F4 Betaflight FC Flight Controller with built in OSD
Also supports iNAV
This is the replacement and upgraded version of the F405 - OSD Board with a lot of improvements.
The F405-STD now features a built in OSD , Barometer and Black Box with MicroSD Card Slot.
STM32F405, ICM20602, BMP280, BFOSD, SD Card Slot, VCP+5x UARTs, 6x PWM / DShot outputs.
The new Matek F405-OSD has built in Betaflight OSD, MicroSD card for blackbox.
Features and Specs
- MCU: 168MHz STM32F405RGT6
- IMU: 32K ICM20602 gyro/accelerometer (SPI)
- Baro: BMP280 (I2C)
- OSD: BetaFlight OSD w/ AT7456E chip
- Blackbox: MicroSD card slot (SD/SDHC)
- VCP, UART1, UART2, UART3, UART4, UART5
- Built in inverter for SBUS input (UART2-RX)
- PPM/UART Shared: UART2-RX
- SoftSerial on TX2, S5 or S6 optional
- Camera control on S6 or DAC optional
- Smartaudio & Tramp VTX protocol supported
- Battery Voltage Sensor: 1:10
- Current Sensor: No (FCHUB-6S, FCHUB-VTX, FCHUB-W option)
- BEC 5V: No (FCHUB-6S, FCHUB-VTX, FCHUB-W option)
- LDO 3.3V: Max.300mA
- I2C1 SDA & SCL: Yes
- WS2812 Led Strip : Yes
- Beeper : Yes
- RSSI: Yes
- 3x LEDs for FC STATUS (Blue, Red) and 3.3V indicator(Red)
- 6x PWM / DShot outputs without conflict
- 2x 2812LED outputs option
- 5x UARTs
- 1x Group of 5V/G/S1/S2/S3/S4 pads for 4in1 ESC Signal/GND
- 4x pairs of corner pads for ESC Signal/GND connections (DSHOT compatible)
- 1x pair I2C1 pads
- 1x Side-press button for BOOT(DFU) mode
- 1x 16pin bottom mounted FFC Slot for FCHUB-6S, FCHUB-VTX or FCHUB-W connection
- 36x36mm PCB with 30.5mm mounting holes
- w/ 2x 0.5mm*16Pin 5cm Flexible Flat Cable
- w/ 4pcs M3 Anti-vibration Standoffs
Note : Please always test the board first using usb connection as returns cannot be accepted once the Flight Controller as been soldered.