Happymodel Crazybee F3 Pro Flight Controller 5A

333 Reward Points
SKU:
Brand: HappyModel

Quantity

ADD TO WISHLIST
Found it cheaper? Click here

Sorry this item is out of stock, please complete in the form below to be notified when stock is available.

QuadCopters Price Match

Where you've seen it cheaper (UK Stores Only)

The Crazybee F3 Pro is a 1-2S Brushless F3 flight controller with internal 4in1 ESC, OSD, and 2.4G receiver. You only need to add a VTX and Camera. It’s the best choice for 2S Brushless tiny whoop such as the Mobula7.

Specifications

Flight controllerCRAZYBEEF3 PRO FS Firmware target: CrazybeeF3FS
MCU: STM32F303CCT6 (72MHZ, 256K FLASH)
Sensor: MPU-6000(SPI connection)
Board size: 28.5 * 28.5MM
Weight:4.2g
Power supply: 1-2S battery input (DC 3.5-8.7V)
Built-in 5A(each) Blheli_S 4in1 ESC Dshot600 ready
Built-in Betaflight OSD(SPI Control)
Built-in Current meter Max 28A
Current meter scale set to 1175
Built-in 5V 1A Buck / Boost with LC filter
Built-in voltage detection
BLHELI_S pass-through Ready
Heading LED Ready
Receiver options: SPI Frsky
Onboard 4in1 ESCMCU upgraded to EFM8BB21
Power supply: 1-2S LiPo/LiPo HV (3.5v/8.7v)
Current: 5A continuous peak 6A (3 seconds)
Support BLHeliSuite programmable
Factory firmware: S_H_50_REV16_7.Hex
Default protocol: DSHOT600


Built-in
Frsky NON-EU receiver
SPI BUS receiver
Frsky D8/D16 switchable
Compatible Non EU transmitter both D8 and D16 mode
Channels: 8ch or 16ch
Failsafe support
No ground interference ( Transmitter and receiver 1 m from the ground): 300m


Includes

  • 1x Flight Controller board
  • Screw and grommet set
  • 1x 2pin pigtail cable
  • 1x 2pin 2S pigtail cable

Write your own review

 

OK

The item has been added to your basket

Continue Shopping
Proceed To Checkout